Cedrus logo
Click on icon to search our website (not including the store).

Support   Lumina LSC-400   Using Lumina with MEDx

Setting Up the Serial Port

The Lumina LP-400 system is compatible right out of the box with MEDx. Placing your Lumina system in MEDx mode is a simple matter of pressing the Mode and Speed push buttons found on the back panel of the controller:

Press the Mode button until the “MEDx” indicator lights up.

Press the Speed button until the “9600 baud” indicator lights up.

Troubleshooting

If MEDx cannot detect a response from your response pads, here is a checklist of things to look for:

The most common reason is usually an incorrect COM port setting. Double-check which COM port your Lumina controller is connected to. If you are not sure, try different COM port settings in MEDx.

If you are sure that the port settings are correct, the second most common problem is when an internal modem is installed. Although it is internal, it might occupy the same port (e.g. COM2) that the Lumina controller is connected to. In this case, try a different COM port or, if no other one is available, please contact the manufacturer of your computer for assistance in re-assigning the modem to another COM port.

If MEDx is receiving data from the Lumina controller but not the data that you expect, then the connection is established but either the baud rate or the protocol is set incorrectly. Verify the settings on the controller and make sure that the baud rate selected matches your setting in MEDx (usually 9600 baud).

Last revision: April 10, 2004

PRODUCTS

SUPPORT

STAY IN TOUCH

© Copyright 2024 Cedrus Corporation, P.O. Box 6309, San Pedro, CA 90734 - USA

Phone: +1-310-548-9595. Send us an email. See privacy policy.

qwerasdf