‍Summary

‍For maximum compatibility with application programs, the response pads offer the following:

• Serial Port Emulation: Once installed, the USB driver sets up a pseudo serial port. Application programs that used to support the serial port can continue to do so with no modifications.
• Keyboard Emulation: The response pad behaves exactly like your computer keyboard and becomes compatible with nearly any software. No USB driver needs to be installed.
• Multiple Protocols: Riponda supports different “protocols” or formats in which the data is sent to the computer. You select the protocol via the black & white switches (called DIP switches) on the bottom of Riponda.

‍This document describes the DIP switch settings. However, if you already know which program you want to use your response pad with, e.g. SuperLab or E-Prime, see the Riponda Support home page for a list of programs.

‍The Switch Settings

‍The DIP switches are located on the bottom of the response pad.

‍It is important to note that the response pad “reads” the position of the switches only when it is powered up. If you change them, you will need to unplug the USB connector and plug it in again for the new settings to take effect.

‍When shipped, all the switches are in the up (On) position. Switch 1 determines the mode: Keyboard (when switch 1 is down) vs. Standard (when switch 1 is up). Switches 2 and 3 determine the protocol used. Switch 4 determines the baud rate (speed) at which the data is sent.

‍

Back to Riponda Support main page
Last Revision: Aug 15, 2023